GIT2P Panasonic MN34120PA sensor version Firmware:

For 170° FOV Lens version:

For 90° FOV Lens version:

GIT2 Sony IMX206 Sensor version Firmware:

Latest and stable firmware, version number is V1.7

(Please read the upgrade instructions first before you upgrade.)

Change Log:

  • 1. Added: Zoom for video, removed FOV option for video
  • 2. Added: External Power option in system settings, removed car DVR option
  • 3. Added: Support quick capture option in configuration file
  • 4. Added: Continues shot for photo: hold the shutter button to take continuous photo.
  • 5. Added: Support using side button for ZOOM while recording
  • 6. Fixed: Video snapshot issue in 2160P mode
  • 7. Improved: Audio sample rate upgraded to 48kHz
  • 8. Improved: Wi-Fi transfer speed.

Upgrade Instructions for V1.7:

  • If you camera firmware version is V1.2 or earlier, please upgrade the loader GIT2LD.bin first.
  • If you have already installed the V1.3 firmware, no necessary to upgrade the loader, please ignore the #3--#6 steps.
  • From V1.4 firmware, the firmware will be automatically deleted from Micro SD card after upgrade completed.
  1.          Use max. 32GB card formatted by camera or on computer as FAT32
  2.          Insert card in camera and connect it to computer using USB cable
  3.          Copy just the GIT2LD.bin on the root of the card
  4.          After GIT2LD.bin is copied to the card disconnect the camera from computer
  5.          Reconnect the camera to your computer and wait few seconds until you can chose Mass Storage from camera menu
  6.          Delete GIT2LD.bin from the card using your PC and
  7.          Copy the GIT2FW.bin file on the root of the card
  8.          Reconnect the camera to your computer and wait more seconds until you can chose Mass Storage from camera menu, the front green LED and back red LED will be blinking while upgrading.

Now you can disconnect the camera from PC and enjoy new GitUp implementations


Upgrade Instructions for V1.2 or earlier:

Please do the following to upgrade the action cam

1. Download the firmware file, and prepare the MicroSD card(use a 32GB maximum,FAT32 format.)

2. Unzip the file using available unzip programs, e.g. WinZip or 7-Zip

3. Open the file and copy the .bin file directly into the MicroSD card Root File(Or you can choose to format your SD card first, then copy the .bin file directly into the MicroSD card)

4. Insert the MicroSD card into the cam and power it on via a 5V/1A power source, e.g. cigarette lighter or power bank, it will start upgrade automatically.

5. While upgrading the photo status green light starts blinking(the light blinking slowly at the beginning, then blinking quickly), after the light stop blinking, it means upgrade is finished. (The whole process lasts about 30 seconds)

6. After upgrade, remove the SD card and delete the firmware, otherwise it will upgrade again when you power on the camera next time. 

Old version Firmware for Git2 Sony IMX206 Sensor version: